Tools required:
Philips Screw Driver
Torque Screw
Window Handle Remover

First you need to remove the window handle (manual windows). Use the window handle remover to remove the window handle. From the round long end place the remover under the handle and push the clip off. Caution: The clip will fly so watch where it goes or block it from the other end. After the clip is off then take handle of.

To remove the door panel there will be two screws and multiple door clips.

One screw will be in the handle that would be grabbed while closing the door. Remove this screw.

The other screw will be in the handle that actually opens the door. Remove this screw.

Grab around edge of door panel and start at the bottom and pull until the door clips start popping out. There will be clips cover the majority of the area.

When the door panel is completely loose then you will need to remove the small bar that is connected from the door handle to the door lock. There will be a clip on this bar that will need to be slid off and the bar will pull out.

If you have power locks, power windows, or power mirrors there will be more connections to remove.

While having the door panel you might think about adjusting your window (How to Adjust Your Window on Neons '95-'99) to avoid wind noise while driving.