Hooking up a Dtec

You will need the following to hook up dtec.

1. Dtec Computer
2. NT SP.
3. Dtec Power wire.
4. wire tape.

First hooked up the power wire as you can see below:



Hint: Hook it to the battery or the radio wires. Red and Black are the main wires. Red is Hot wire and Black is Ground. If you are going to travel them to the battery you should know the hot and ground wires you are using. The dtec FC hot and ground wire colors are RED and Black ( Red Hot wire ) ( Black Ground Wire )

Then hide all wiring and hooked up the POWER WIRE CONNECTOR TO DTEC COMPUTER
Like you see below:



Then hook the knocklight connector and hooked it to the fourth connector from the right on this picture:



Then hook the DTEC wires that go to the NT SP and put them through the dash and hook them up to the NT SP.



Then power your car up and turned the NT SP on and it loads all the information from the car:




Thats how you hook up DTEC .

How to by Cody
neondtecequipment.com